Principles and limitations of micro-fabrication process in semiconductor devices for high-speed operation and high-density integration are described. After explanation of requirement of simultaneous miniaturization in vertical direction and lateral direction for high speed operations, latest technology with focusing on lithography is explained. Then, diffusion region, etching, oxidation, film deposition, and metallization are described.
By the end of this course, students will be able to:
1) Explain outlines of semiconductor processes which fabricated integrated circuit for popularization of low-cost and high-speed electric circuits.
2) Understand the guidelines for higher integration and speed.
3) Understand the method for miniaturization based on the scaling from principle operation of MOSFETs.
Integrated circuits, CMOS, memory, lithography, diffusion region, etching, oxidation, film deposition, metallization
Specialist skills | Intercultural skills | Communication skills | ✔ Critical thinking skills | Practical and/or problem-solving skills |
✔ ・Applied specialist skills on EEE |
Because of the large amount of knowledge, basic problems will be explained during the lecture. Any textbook or notebook is able to be used for the examination.
Course schedule | Required learning | |
---|---|---|
Class 1 | Requirements of semiconductor fabrication process and basis of optical lithography | Calculation of resolution for lithography process |
Class 2 | Advanced optical lithography and electron beam lithography | Evaluation of resolution and proximity correction in lithography |
Class 3 | Short channel effect and scaling for MOSFET | Explanation of self-aligned process |
Class 4 | Scaling of gate insulator and source/drain diffusion regions | Extraction of SiO2 thickness and contact resistivity |
Class 5 | Scaling and technology booster | Explanation of strained-channel, high-k gate insulator, and SOI substrate |
Class 6 | Advanced memory and integration process | Calculation of wiring delay |
Class 7 | Examination |
To enhance effective learning, students are encouraged to spend approximately 100 minutes preparing for class and another 100 minutes reviewing class content afterwards (including assignments) for each class.
They should do so by referring to textbooks and other course material.
N/A
Distributed by T2SCHOLA.
Evaluate based on the students' knowledge of semiconductor processes.
Report 30%, Examination 70%
NA