- 使用教室
- 金3-4(M112)
- 単位数
- 講義：2 演習：0 実験：0
- 講義コード
- 61061
- シラバス更新日
- 2011年9月20日
- 講義資料更新日
- 2011年9月20日
- 学期
- 後期
講義概要
This course covers scaling laws and modeling considerations for physical modeling in geotechnical problems both for static and dynamic conditions with laboratory exercises.
01.Introduction
02.Similitude and modeling principle
03.Design of physical model and model ground preparation
04.Model planning and measurement strategy
05.Sensors
06.Recent development in physical modeling
07.Modeling exercise
講義の目的
To learn fundamental knowledge and techniques related to physical modeling in geotechnical boundary value problems, including similitude, principles of measurement and test program strategy and to understand the usefuless of physical modeling through lectures and modeling exercise with presentations and discussions.
講義計画
1. Introduction + visit Tokyo Tech geotechnical centrifuge facilities
2. Similitude and modeling principles
3. Design of physical model and model ground preparation
4. Modeling exercise 1: preparation of dry sand model ground in a mould
5. Measurements strategy and sensors
6. Modeling exercise 2: Bearing capacity of shallow foundation on dry sand
7. Modeling exercise 2: continue
8. Recent development in physical modeling - static problems
9. Presentation of exercise results and discussion - Exercises 1 & 2
10. Recent development in physical modeling - dynamic problems
11. Modeling exercise 3: Response of a single pile in sand during earthquake
or under cyclic lateral loading (1G model or centrifuge model ): Proposal
12. Modeling exercise 3: contitue
13. Modeling exercise 3: continue
14. Presentation of exercise results and discussion - Exercise 3
15. Examination
教科書・参考書等
Handouts on each topic will be provided by lecture.
Reference:
Geotechnical Centrifuge Technology(Blackie Academic & Professional)
関連科目・履修の条件等
None
成績評価
Assignments, Exercise & Examination
